Winterization And Storage
Indoor Storage Rates (September 1st - June 1st)
NO Triple Toon Manitou Pontoons without trailers
-
PWC on a trailer $399 / No trailer $499
- Two Place PWC $749
-
All Other Trailerable Boats
- Under 20 feet $749
- 21 feet - 25 feet $949
- 26 feet - 30 feet $1,299
- All Non Foldable Tower or T-Top $1,299
-
Racked Boat Storage
- Up to 20 feet $699
- 21 feet - 22 feet $949
- 23 feet - 27 feet $1,299
- Over 8' 6" up to 31 feet long $1,999
-
Miscellaneous
- Shrink Wrap $15.00 per foot
- Outside Storage $329
- Pick Up or Delivery
- Must be a DNR approved boat ramp.
- Houghton Lake South Shore $55.00
- All Other Houghton Lake Launches $75.00
- Higgins Lake $100
- St Helen $100
- Lake James $75
- Lake Missaukee $125
- Sugar Springs $150
- Lake Margrethe $150
- Call for additional lakes. Long hauls are $4 per loaded mile. $200 none refundable deposit is required to hold your spot.
Stern Drive Winterization Only
Stern drive silver winterize
- Add Fuel Stabilizer to the Boat’s Fuel Tank
- Run Engine/Drive In Anti-Freeze
- Observe Maximum Engine Operating Temperature
- Inspect For Proper Engine Oil Level @ Dipstick
- Observe Oil PSI (@ 2500 RPM and @ Idle)
- Drain intermediate housing
- Fog engine
- Disconnect Battery
- Remove drain plug- install warning tag
Stern drive gold winterize
- Change Engine Oil
- Change Oil Filter
- Change Fuel Separating Filter
- Change Drive Gear Lube
- Grease all Zerks Inside the Boat
- Grease all Accessible Zerks Outside the Boat
- Add Fuel Stabilizer to the Boat’s Fuel Tank
- Run Engine/Drive In Anti-Freeze
- Observe Maximum Engine Operating Temperature
- Inspect For Proper Engine Oil Level @ Dipstick
- Observe Oil PSI (@ 2500 RPM and @ Idle)
- Drain intermediate housing
- Fog engine
- Disconnect Battery
- Remove drain plug- install warning tag
Stern drive platinum winterize
- Inspect U-Joints
- Grease U-joints
- Inspect Gimbal Bearings
- Inspect Bellows
- Replace Drive Shaft “O” rings
- Lubricate Splines
- Inspect Engine Alignment
- Change Engine Oil
- Change Oil Filter
- Change Fuel Separating Filter
- Change Drive Gear Lube
- Grease all Zerks Inside the Boat
- Grease all Accessible Zerks Outside the Boat
- Add Fuel Stabilizer to the Boat’s Fuel Tank
- Run Engine/Drive In Anti-Freeze
- Observe Maximum Engine Operating Temperature
- Inspect For Proper Engine Oil Level @ Dipstick
- Observe Oil PSI (@ 2500 RPM and @ Idle)
- Drain intermediate housing
- Fog engine
- Disconnect Battery
- Remove drain plug- install warning tag